Pressure Tank Installation & Repair in Hays County

Pressure Tank Installation & Repair

The pressure tank is what gives your home steady water pressure and keeps your pump from running every time you open a faucet. Inside, a captured air charge (usually behind a rubber bladder) stores pressurized water so the pump only kicks on when the tank draws down — protecting the pump and smoothing out your pressure. When a tank fails, you get telltale problems: the pump short-cycles on and off, water pressure surges and drops, pipes bang, or the tank feels waterlogged and heavy. We install and repair pressure tanks across Hays County. We test the tank’s air charge and bladder, set the pressure switch correctly, and replace a failed or undersized tank with the right size for your home and pump. A correctly sized, healthy pressure tank is one of the cheapest ways to protect an expensive pump and get consistent water pressure throughout the house.

What the pressure tank actually does

Without a pressure tank, your pump would start and stop every time anyone ran water — burning it out in no time. The tank stores a cushion of pressurized water using a captured air charge, so the pump runs in longer, less frequent cycles and your pressure stays steady. A tank that has lost its air charge or failed its bladder can no longer do that job, and the pump pays the price. Keeping the tank healthy is the simplest pump-protection there is.

Signs your tank is failing

A failing pressure tank shows itself fast: the pump clicks on and off rapidly (short-cycling), water pressure surges then drops as you use it, the tank feels completely full and heavy when you rock it, or you hear pipes hammering. Left alone, that constant cycling will take out the pump, which is a far bigger bill than a tank. If you notice these signs, getting the tank checked is cheap insurance.

Sizing and setting it right

A tank that is too small makes the pump cycle too often; one that is sized correctly and charged to the right pressure lets the pump rest. We match the tank to your pump and household demand, set the air charge a couple of pounds below the pump cut-in pressure, and dial in the pressure switch so the system runs smoothly. Done right, you get steady pressure and a pump that lasts.

What’s included

• Pressure tanks installed and replaced — sized to your pump and home
• Air charge and bladder tested; failed tanks replaced
• Pressure switch set and dialed in for steady pressure
• Short-cycling and pressure-fluctuation problems fixed
• Protects your pump from premature failure
• Honest sizing — no oversized tank you don’t need